Micro Controle – Automação Electrónica, Lda.

Products

by Fmeaddons

Level control box for tank – QN QED

Level Control Box for Tanks

This product is currently out of stock and unavailable.

Product Description

Level Control box used for protection of submersible water pumps used in the supply of pressurized water tanks or cisterns.

Note: The images shown may not correspond completely to the product described.

Additional information

WeightN/A
DimensionsN/A
Thermal regulation

1,6 – 2,5 A, 2,5 – 4,0 A, 4,0 – 6,0 A, 5,5 – 8,0 A, 7,0 – 10,0 A, 9,0 – 13,0 A

Supply

230V, 400V

Gray ABS case

195x257x147mm ABS plastic box with hinges and cristal polycarbonate lid

Level relay

trademark micro controle, for lack of water protection

Contactor, overload relay and a circuit breaker

requested trademark

3 positions toggle switch

with rubber cap for controlling Automatic (AUT), Manual (MAN) or Off (OFF) mode system

Start/Stop remote control connection

(P11-P12) (pressure-switch, float-switch or other)

Accessories / Others

Pressure switch, buoy or others; 4 cable glands for connection cables

Applications

Level control in tanks or reservoirs

Protection against water shortage, red led access when there is water level below the minimum level probe (close dry contact to start the electropump to reset level)

Protection against short-circuits by a circuit breaker – 16A

Protection against overloads by an overload relay – IP54 IK07

Lack of water in the tank (red LED on the level relay)

Running motor status(green LED on the level relay)

Overload trip staus (red LED on the level relay)

Operation

Make the connections, as indicated on the sticker, with the switch on (off).

Set the thermal relay to the rated motor current.

Switch the switch to automatic (aut).

After contacting the P11 and P12 contacts, the contactor will arm when the water level reaches the minimum level probe (red LED F.A. – water shortage), switching off when the contact pair P11 and P12 open, or if the level Of water rise beyond the maximum level probe (extinguishes the red LED – lack of water).

If the control circuit switch is in the manual (manu) position, the pump switches on regardless of the control status of the contact pair P11 and P12 and the level condition.

In case of tripping of the thermal relay (overload), the pump switches off (red LED D.T. on the level relay), regardless of the information provided by any of the other controls.